Robopac ECOPLAT PLUS BASE - Periodical Maintenance Intervals

63
MAINTENANCE INFORMATION
ENG
7.2. PERIODICAL MAINTENANCE INTERVALS
Important
Keep the machine in maximum efficiency conditions and perform all the scheduled maintenance
operations provided for by the Manufacturer.
Proper maintenance will provide the best performance, a longer life span and constant compliance with
safety requirements.
Maintenance interval table
Frequency
Component
Type of intervention
Intervention mode
Reference
Every 40 hours or
1000 cycles (*)
Machine
Cleaning
cloth or
air blow
-
Every 200 hours or
5000 cycles (*)
Rubber rollers
Cleaning
Clean with alcohol
-
Lifting chains
Greasing
-
See “Lubrication
point diagram”
Tensioning check
Adjust
See “Film carriage
lifting chain
adjustment”
Table rotation
chain
Greasing
-
See “Lubrication
point diagram”
Tensioning check
Adjust
See “Rotary table
chain adjustment”
Reduction units
and gearmotors
Checking lubricant
level
1
Top up, if necessary,
with lubricant of the
same type
See lubricant table
Every 2000 hours
or 10000 cycles (*)
Lifting chains
Wear check
-
-
Safety devices
Efficiency check
-
-
Table rotation
chain
Wear check
-
Every 5000 hours
or 50000 cycles (*)
Rotary table
wheels
Replacement
-
See “Replacing the
rotary table wheels”
Carriage lifting
wheels
Replacement
-
-
Reduction units
and gearmotors
Lubricant change
1
Use lubricant with the
same characteristics
See lubricant table
1
Reduction units and gearmotors can be lubricated with grease, oil or for life, depending on their type.
Topping up and/or change must not be performed in case of life-lubed reduction units and gearmotors.
 Cycle timings have been defined on the basis of the standard cycle.
The standard cycle is the following: 500 mm high film reel, 1500 mm high pallet, pallet weight equal to 1500 kg,
total wrapping cycle consisting of two turns at the base, two turns at the top with rotation speed of 12 r.p.m. or
80 m/1’ and carriage upstroke and downstroke speed equal to 4 m/1’.