Robustel GoRugged R2000 User Guide
RT_UG_R2000_v.1.2.0 15.12.2015 111 /120
Confidential
5.2 How to Configure the CLI
Following is a list about the description of help and the error should be encountered in the configuring program.
Typing a question mark “?” will show you the help information.
Press these two keys at the same time, except its “copy” function but also
can be used for “break” out of the setting program.
Syntax error: The command is not
completed
Command is not completed.
It can help you finish you command.
Example:
# config (tick Enter key)
Syntax error: The command is not completed
# config (tick space key+ Tab key)
commit save_and_apply loaddefault
# config save_and_apply /
#config commit
When you finish your setting, you should enter those commands to make
your setting take effect on the device.
Note: commit and save_and_apply plays the same role.
5.2.1 QuickStart with Configuration Examples
The best and quickest way to master CLI is firstly to view all features from the webpage and then reading all CLI
commands at a time, finally learn to configure it with some reference examples.
Example 1: Show current version
# status system
hardware_version = 1.0
firmware_version = "1.2.0 (Rev 399)"
kernel_version = 3.10.49
device_model = R2000
serial_number = 15090140040008
uptime = "0 days, 00:04:07"
system_time = "Tue Dec 22 15:02:36 2015"
Example 2: Update firmware via tftp
# tftpupdate (space+?)
firmware New firmware
# tftpupdate firmware (space+?)
String Firmware name
# tftpupdate firmware r2000-firmware-sysupgrade-unknown.bin host 192.168.100.99 //enter a new firmware name
To Next Page
Loading...
Need help?
General
