Robustel GoRugged R2000 User Guide
RT_UG_R2000_v.1.2.0 15.12.2015 28 /120
Confidential
3.6 Interface->Link Manager
Link Manager
User can manage the link connection in this section.
Select from “WWAN1”, “WWAN2”, “WAN”, “WLAN”.
1. WWAN1: Select to make SIM1 as the primary wireless link.
Note: insert SIM card please refer to the installation quick guide.
2. WWAN2: Select to make SIM2 as the primary wireless link.
3. WAN: Select to make WAN Ethernet port as the primary link.
Note: WAN link available only if enable ETH0 as WAN interface in
System->Device Configuration->Advance Device Settings
4. WLAN: Select to make WLAN as the router’s primary link.
Note: WLAN link available only if enable R2000 as WiFi Client in
System->Device Configuration->Advance Device Settings
Select from “None”, “WWAN1”, “WWAN2”, “WAN”, “WLAN”.
1. None: Do not select backup interface.
2. WWAN1: Select to make SIM1 as backup wireless WAN.
3. WWAN2: Select to make SIM2 as backup wireless WAN.
4. WAN: Select to make WAN Ethernet port as the backup WAN.
Note: WAN link available only if enable ETH0 as WAN interface in
System->Device Configuration->Advance Device Settings
5. WLAN: Select to make WLAN as the router’s backup link.
Note: WLAN link available only if enable R2000 as WiFi Client in
System->Device Configuration->Advance Device Settings
Cold backup: The inactive link is offline on standby.
Warm backup: The inactive link is online on standby.
Warm backup mode is not available for dual SIM backup.
Enable to reboot the whole system if no links available.
To Next Page
Loading...
Need help?
General
