Robustel GoRugged R2000 - Interface->WLAN (Optional)

Robustel GoRugged R2000 User Guide
RT_UG_R2000_v.1.2.0 15.12.2015 50 /120
Confidential
This section allow user to check the AP status and those WiFi client had connected to R2000 AP.
3.11 Interface->WLAN (Optional)
R2000 router support both WiFi AP and WiFi client. The factory default setting of R2000 is as WiFi AP.
This section allow user to configure the R2000 router as a WiFi client and set the related parameters.
WiFi Client
Configure R2000 as a WiFi client
Go to System->Device Configuration, select the WiFi mode as Client, click “Submit” and reboot the device to make
the setting effect.