Robustel GoRugged R2000 User Guide
RT_UG_R2000_v.1.2.0 15.12.2015 49 /120
Confidential
Select from “20MHz”, “40MHz”.
40 MHz channel width provides twice the data rate available over a single
20 MHz channel.
Click “ON” to enable WMM.
Click “ON” to enable Short GI (Short Guard Interval), short GI is a blank
time between two symbols, it can provide a long buffer time to delay
signal.Using the Short Guard Interval would provide an 11% increase in
data rates, but also may result in higher packet error rates.
Isolate all connected wireless stations so that wireless stations cannot
access each other through WLAN.
Select from “verbose”, “debug”, “info”, “notice”, “warning”, “none”.
Click to enable ACL (Access Control List).
Select from “Accept” and “Deny”.
Accept: Only the packets fitting the entities of the “Access Control List”
can be allowed.
Deny: All the packets fitting the entities of the “Access Control List” will
be denied.
Note: R2000 can only allow or deny devices which are included in
“Access Control List” at one time.
Click “ ” to add MAC address.
To Next Page
Loading...
