Robustel R2000 User Manual

Robustel R2000 User Guide
RT_UG_R2000_v.3.0.0 July 24, 2017 16 / 124
Confidential
Note: You can choose the display type of USR LED. For more details, please refer to 3.25 Service > Advanced.
2.3 Reset Button
than standard
Off
Network is not joined or joining
USR-OpenVPN
Green
On, solid
OpenVPN connection is established
Off
OpenVPN connection is not established
USR-IPsec
Green
On, solid
IPsec connection is established
Off
IPsec connection is not established
USR-WiFi
Green
On, solid
WiFi is enabled and working properly
Off
WiFi is disabled or not working properly
Green
On, solid
High Signal strength (21-31) is available
On, solid
Medium Signal strength (11-20) is available
On, solid
Low Signal strength (1-10) is available
Off
No signal
On, blinking
When the network is disconnected, those three signal
LEDs are designed as a binary combination code to
indicate a series of error report.
Blinking: 1 Off: 0
001 AT command failed
010 no SIM card detected
011 need to enter the PIN code
100 need to enter the PUK code
101 registration failed
110 module error
111 not support the module
Function
Operation
Reboot
Press and hold the RST button for 2 to 7 seconds under the operating status.
Restore to factory
default settings
Wait for 5 seconds after powering up the router, press and hold the RST button until all six
LEDs start blinking one by one, and release the button to return the router to factory
defaults.

Robustel R2000 Specifications

General

Model	R2000
Category	Network Router
Cellular Connectivity	4G LTE
WAN Ports	1
Ethernet Ports	2
Input Voltage	9-36 VDC
SIM Slots	2
Certifications	CE, FCC, RoHS
Operating Temperature	-40°C to 75°C