Rohde & Schwarz CMU 300 User Manual

Figures CMU
1100.4903.12 4 E-9
Fig. 4-31
Connection Control – RF connectors ................................................................................. 4.64
Fig. 4-32 Connection Control – Synchronization............................................................................... 4.67
Fig. 4-33 Measurement menu Analyzer/Generator (Audio) .............................................................. 4.75
Fig. 4-34 Display of test settings and measurement results (Audio)................................................. 4.77
Fig. 4-35 Analyzer Configuration – Control ....................................................................................... 4.79
Fig. 4-36 Analyzer Configuration – Generator................................................................................... 4.80
Fig. 4-37 AF analyzer input path configuration.................................................................................. 4.81
Fig. 4-38 Analyzer Configuration – Filter........................................................................................... 4.81
Fig. 4-39 Measurement menu Multitone............................................................................................ 4.83
Fig. 4-40 Display of measurement results (Multitone)....................................................................... 4.86
Fig. 4-41 Multitone Configuration – Control....................................................................................... 4.88
Fig. 4-42 Multitone Configuration – Limit Lines ................................................................................. 4.90
Fig. 4-43 Multitone Configuration – Tone Def.................................................................................... 4.91
Fig. 4-44 Signal path for Multitone measurements............................................................................ 4.92
Fig. 4-45 Multitone Configuration – Filter........................................................................................... 4.93
Fig. 4-46 I/Q-IF Interface.................................................................................................................... 4.95
Fig. 5-1
Remote screen ......................................................................................................................5.3
Fig. 5-2 Example for the tree structure of the SCPI command systems; the SOURce system..........5.8
Fig. 5-3 Instrument model in the case of remote control via GPIB bus........................................... 5.13
Fig. 5-4 The status register model................................................................................................... 5.16
Fig. 5-5 The status registers............................................................................................................5.19
Fig. 5-7 Measurement states and control commands ..................................................................... 5.29
Fig. 5-8 Generator states and control commands ........................................................................... 5.33
Fig. 8-1
Pin Assigment of the GPIB bus interface ..............................................................................8.2
Fig. 8-2 Pin assignment of the RS-232-C interface............................................................................8.5
Fig. 8-3 Wiring of the data lines for software handshake ...................................................................8.8
Fig. 8-4 Wiring of the data, control and message lines for hardware handshake..............................8.9
Fig. 8-5 Pin assignment of the LPT connector ................................................................................ 8.10
Fig. 8-6 Pin assignment of the MONITOR connector...................................................................... 8.11
Fig. 8-7 Pin assignment of the KEYBOARD socket ........................................................................ 8.11
Fig. 8-8 RF connectors .................................................................................................................... 8.12
Fig. 8-9 Inputs and outputs for reference frequency ....................................................................... 8.12
Fig. 8-10 AF connector SPEECH ...................................................................................................... 8.13
Fig. 8-11 IF signal output................................................................................................................... 8.13
Fig. 8-12 SERVICE connector........................................................................................................... 8.13
Fig. 8-13 AUX connector ...................................................................................................................8.14
Fig. 8-14 AUX 3 connector ................................................................................................................ 8.14
Fig. 8-15 AUX 4 connector ................................................................................................................ 8.15
Fig. 8-16 ABIS connector................................................................................................................... 8.15
Fig. 8-17 I/Q CH1 connector.............................................................................................................. 8.16
Fig. 8-18 IF3 connectors.................................................................................................................... 8.17

Rohde & Schwarz CMU 300 Specifications

General

Brand	Rohde & Schwarz
Model	CMU 300
Category	Test Equipment
Language	English