Rohde & Schwarz FSH3 - Page 10

R&S FSH3 Specifications
Calibration standards
Short/open
Connector N male
50 Ω load
Impedance
50 Ω
Return loss up to 3 GHz >46 dB
Power-handling capacity 1 W
Connector N male
General data
Power consumption 500 mW (nominal)
Dimensions (W x H x D) 169 mm x 116 mm x 30 mm
Weight 485 g
Distance-to-fault measurements (option R&S FSH-B1, only model 1145.5850.13 or 1145.5850.23)
Display 301 pixels
Maximum resolution, distance to fault cable length/1023 pixels (maximum zoom)
Display range
Return loss
VSWR
10, 5, 2, 1 dB/div, linear
1-2 and 1-6,
with option R&S FSH-K2 also 1-1.2 and 1-1.5
Cable length 3 m to 1000 m max.
(depending on cable attenuation)
Maximum permissible spurious signal 1st mixer 1 dB compression point +10 dBm typ.
IF overload at reference level +8 dB typ.
Transmission measurements (only model 1145.5850.13 or 1145.5850.23)
Frequency range 10 MHz to 3 GHz
Dynamic range
10 MHz to 2.2 GHz
2.2 GHz to 3 GHz
60 dB (scalar measurements)
80 dB (vector measurements, option R&S FSH-K2)
50 dB (scalar measurements)
65 dB (vector measurements, option R&S FSH-K2)
Reflection measurements (only model 1145.5850.13 or 1145.5850.23 with R&S FSH-Z2)
Frequency range 10 MHz to 3 GHz
Display range of return loss 10 dB, 20 dB, 50 dB, 100 dB, selectable
VSWR display range 1-2 and 1-6, selectable,
with option R&S FSH-K2 also 1-1.2 and 1-1.5
Measurement uncertainty see diagram
1145.5973.12 TI.5 E-6