Saving and Loading Instrument Settings and Measurement Results R&S FSH3
The data set name comprises a text section and a numerical extension, which are separated by a full
stop. The data set name suggested by the R&S FSH3 is derived from the name of the data set last
stored, the numerical extension being incremented by 1 in each case.
This means that consecutive data set names can be assigned by simply saving with SAVE or ENTER.
The names of the data sets already stored can be displayed one after the other using the BACK key.
This allows, for example, to store new results under the name of a previous data set (for example
Antenna.000), but with a new extension. The R&S FSH3 displays the old name together with the first
unassigned extension, e.g. Antenna.001. No new name has to be entered.
Entering a data set name
A new name can be entered with the numerical keypad. The letter assignment for the keypad is the
same as that for a mobile phone
ENTER key
BACK key
CANCEL key
Alphanumeric
keypad
If the R&S FSH3 is expecting a letter entry, it automatically assigns the letters above the keys to the
keys in the alphanumeric keypad. The keys have a multiple assignment. Enter the letter you want by
pressing the key in question the appropriate number of times.
¾ Using the alphanumeric keypad enter a name for the data set and terminate the entry with the
ENTER key.
The data set is saved to the R&S FSH3’s internal memory under the name that has been given.
1145.5973.12 4.86 E-6
To Next Page
Loading...
