Rohde & Schwarz FSH3 - Printing out Measurement Results

R&S FSH3 Printing Out Measurement Results
1145.5973.12 2.23 E-6
Printing Out Measurement Results
The R&S FSH3 can print out screen shots to a printer equipped with a serial interface. The type of
printer and the baud rate of the serial interface are set in the setup menu (SETUP key) using the
GENERAL softkey and the 'PRINTER BAUD...' and 'PRINTER TYPE...' menu items. For printers with a
parallel interface a serial/parallel converter (R&S FSH-Z22) is available.
Printer with serial interface:
¾ Connect the printer to the optical interface using the RS232 optical interface cable.
Printer with parallel interface:
¾ Connect the RS232 optical interface cable to Serial/Parallel Converter R&S FSH-Z22.
¾ Connect the R&S FSH-Z22 parallel interface to the printer.
¾ Switch on the Serial/Parallel Converter R&S FSH-Z22
Operating the R&S FSH3:
¾ Press the SAVE / PRINT key.
The SAVE/PRINT menu with the option for printing out
a screen shot to a printer opens.
¾ Press the SCREEN->PRINTER softkey.
The R&S FSH3 starts printing out the screen shot to a
printer.