R&S FSH3 Putting into Operation
Screen Settings
The R&S FSH3’s screen is a transflective, passive color LCD. Indoors, its brightness depends on the
intensity of the backlighting. If light irradiation is strong, the ambient light supports readability. The
viewing angle can be optimized by adjusting the contrast. To achieve maximum contrast, the screen
can be switched from color display to black-and-white display.
To strike a balance between battery operating time and screen display quality, set backlighting to the
minimum brightness needed.
Setting brightness
¾ Press the SETUP key.
¾ Press the DISPLAY softkey.
The submenu with the contrast, lighting and color
settings opens.
¾ Use the Rotary knob or the Cursor keys to select
LIGHT... and confirm the selection by pressing the
DISPLAY softkey or the ENTER key again.
The BACKLIGHT sub-menu for the lighting level
opens. The level can be set to HIGH, NORMAL and
LOW.
¾ Use the Rotary knob or the Cursor keys to select the
setting you want and confirm the selection by
pressing the DISPLAY softkey or the ENTER key.
S
etting the contrast
¾ Press the SETUP key.
¾ Press the DISPLAY softkey.
The submenu with the contrast, lighting and color
settings opens.
¾ Use the Rotary knob or the Cursor keys to select
CONTRAST... and confirm the selection by pressing
the DISPLAY softkey or the ENTER key again.
The contrast value entry box opens.
¾ Use the Rotary knob to adjust the contrast until the
screen readability is optimal.
When setting the contrast view the display at the same
angle that will be used for the application.
¾ Confirm the entry with the ENTER key or by
pressing the DISPLAY softkey again.
The R&S FSH3 displays the setting in the Display
Contrast line in the overview of the setup settings.
1145.5973.12 1.7 E-6
To Next Page
Loading...
