Putting into Operation R&S FSH3
Setting the Date and Time
The R&S FSH3 has an internal clock that can date and time stamp, e.g. outputs to a printer or stored
data records. The user can reset the date and time.
Setting the date
¾ Press the SETUP key.
¾ Press the GENERAL softkey.
¾ Use the Rotary knob or the Cursor keys to select the
DATE... menu item and confirm the selection with
the ENTER key.
The value entry box above the row of softkey labels is
highlighted in red and displays the currently set date in
the selected format (dd/mm/yyyy or mm/dd/yyyy). The
active value entry field is highlighted in white.
¾ Depending on the date format, change the day (dd)
or month (mm) with the Rotary knob, Cursor keys or
a numerical entry and confirm the entry with the
ENTER key.
After the entry, the cursor automatically goes to the
second field in the date (day or month, depending on
the date format). Proceed with the next two fields as
with the first.
After the last data block has been entered, the R&S FSH3 verifies the validity of the entered date. If the
date is not valid, the R&S FSH3 sets the next valid date.
Setting the time
¾ Press the SETUP key.
¾ Press the GENERAL softkey.
¾ Use the Rotary knob or the Cursor keys to select the
TIME... menu item and confirm the selection with the
ENTER key.
The value entry box above the row of softkey labels is
highlighted in red and displays the currently set time in
the hours:minutes format. The hours display is
highlighted in white to enter a new value.
¾ Change the hours with the Rotary knob, Cursor keys
or numerical entry and confirm the entry with the
ENTER key.
After entry, the cursor automatically goes to the
minutes display. The entry is the same as for the hours
display.
After the minutes have been entered, the R&S FSH3 verifies the validity of the entered time. If the time
is not valid, the R&S FSH3 sets the next valid time.
1145.5973.12 1.10 E-6
To Next Page
Loading...
