R&S FSH3 Instrument Default Setup
4 Instrument Functions
Instrument Default Setup
When you press the PRESET key, the R&S FSH3 is set to its default setup or presets. It is best to
select the PRESET when you are going to perform a new measurement task. The new settings can
then be made on the basis of the more familiar default setup without the old settings affecting the
measurement.
Operating sequence:
¾ Press the PRESET key (green key below and to the right of the rotary knob).
The R&S FSH3 is immediately set to the default setup.
Status Display
The R&S FSH3 has a status display. On the screen, the status display provides an overview of all the
measurement parameters that have just been set. This means that all the measurement settings can be
checked easily at a glance. The status display can be output directly to a printer as measurement
documentation. At a later date, every detail of a measurement can, therefore, be accurately reproduced.
Operating sequence:
¾ Press the STATUS key (above and to the right of the rotary knob).
The R&S FSH3 displays the current measurement
parameter settings on the screen. To view all settings,
the screen content can be scrolled through with the aid
of the cursor keys or the rotary knob. An up or down
arrow at the right screen edge indicates that additional
information is available before or after the displayed
window. The display can be used as a way of checking
the settings. Settings can be changed by using the
appropriate key and menu.
Printing out the status display:
¾ Press the STATUS -> PRINTER softkey.
The R&S FSH3 immediately prints out a screenshot to
the connected printer. The softkey remains active for
about ½ second (red highlighting).
Exiting the status display:
¾ Press the EXIT softkey or the STATUS key.
The R&S FSH3 returns to the original setting.
1145.5973.12 4.1 E-6
To Next Page
Loading...
