R&S FSH3 Putting into Operation
Setting up the Instrument
The Handheld Spectrum Analyzer R&S FSH3 has been designed for operation in labs as well as for on-
site use for service and maintenance applications.
For any application, the R&S FSH3 can be set up to optimize ease of operation and the viewing angle
of the display.
When used as a desktop instrument, the R&S FSH3
can either be laid flat or it can be stood up using the
fold-out support at the back.
The R&S FSH3 can be laid flat for operation from
above. Because the grip is slightly raised at the back,
the R&S FSH3 is tilted forward to give the optimum
viewing angle for the display.
For use as a desktop, fold out the support at the rear
so that the instrument can easily be operated from the
front and the display can be read easily (see Fig.).
For on-site installation and service measurements, it is
best to hold the instrument with both hands. All the
controls are easy to reach (e.g. with your thumbs). Use
the R&S FSH-Z25 carrying bag so that you have both
hands free to adjust the DUT. The R&S FSH3 can be
attached to the loop provided on the open bag for this
purpose.
Attach the instrument to the bag by securing the carrying handle to the front of the carrying bag with the
Velcro tape.
The carrying handle at the top of the R&S FSH3 is also suitable e.g. for attaching the instrument to
cabinet doors.The shape of the grip ensures that the instrument does not fall off.
1145.5973.12 1.3 E-6
To Next Page
Loading...
