R&S FSH3 Putting into Operation
Country-Specific Settings
The R&S FSH3 is “multilingual” and can display text in the language of your choice. The softkey
lettering is always in English. The default setting (factory-setting) is also English.
Selection
¾ Press the SETUP key.
The R&S FSH3 displays all default settings. The last
two lines indicate the current language and the date
format.
¾ Press the LOCAL SETTINGS softkey.
A sub-menu with the LANGUAGE..., DATE FORMAT...
and UNIT OF LENGTH... entries opens. This menu
allows the entry of a country-specific language, date
format or the unit of length used by the R&S FSH3.
¾ Use the Rotary knob or the Cursor keys to select the
LANGUAGE... menu item you want and confirm the
selection with the ENTER key or by pressing the
LOCAL SETTINGS softkey again.
The languages available are displayed in a sub-menu.
The selected language is highlighted in red.
¾ Use the Rotary knob or the Cursor keys to select the
language you want.
The originally selected language is highlighted in
green. The red bar indicates the new selection.
¾ Confirm the new selection with the ENTER key or by
pressing the LOCAL SETTINGS softkey.
¾ Use the Rotary knob or the Cursor keys to select the DATE FORMAT... menu item and confirm the
selection with the ENTER key or by pressing the LOCAL SETTINGS softkey again.
¾ Use the Rotary knob or the Cursor keys to select the date format (dd/mm/yyyy or mm/dd/yyyy) and
confirm with the ENTER key.
¾ Use the Rotary knob or the Cursor keys to select the UNIT OF LENGTH... menu item and confirm
the selection with the ENTER key or by pressing the LOCAL SETTINGS softkey again.
¾ Use the Rotary knob or the Cursor keys to select the required unit of length (METER or FEET) and
confirm the selection with the ENTER key.
Note: The unit of length is relevant only with distance-to-fault cable measurements to display the
fault distance from the measurement plane.
1145.5973.12 1.9 E-6
To Next Page
Loading...
