R&S FSH3 Connecting Printers
Note: The R&S FSH-Z22 is designed for a data transmission rate of max. 38400 baud (= default
setting). Therefore, set the baud rate (PRINTER BAUD RATE) in the SETUP menu to
38400 baud. The baud rates 9600 baud and 19200 baud can also be set on the R&S FSH-
Z22 by opening the ist cabinet.
Selecting a printer
¾ Press the SETUP key on the R&S FSH3.
The R&S FSH3 displays the selected printer and its
baud rate in the setup settings.
To select another printer, proceed as follows:
¾ Press the GENERAL softkey.
¾ Use the Rotary knob or the Cursor keys to select the
PRINTER TYPE... menu item and confirm the entry
with the ENTER key or by pressing the GENERAL
softkey again.
¾ Use the Rotary knob or the Cursor keys to select the
printer you want and confirm the entry with the
ENTER key or by pressing the GENERAL softkey
again.
The R&S FSH3 displays the selected printer under
"Printer Type".
Next, set the baud rate for the selected printer.
¾ Press the GENERAL softkey.
¾ Use the Rotary knob or the Cursor keys to select the
PRINTER BAUD... menu item and confirm the
selection with the ENTER key.
The selection box for the baud rates available
(1200 baud to 115200 baud) opens.
¾ Use the Rotary knob or the Cursor keys to select the
baud rate you want and confirm the entry with the
ENTER key or by pressing again the GENERAL
softkey.
The R&S FSH3 displays the selected baud rate under
"RS232 Baudrate" in the setup display.
Note: If the serial/parallel converter (R&S FSH-Z22) is used to control a printer with a parallel
interface, set the RS232 interface to 38400 baud.
The contents of the setup display can be output to the printer by pressing the SETUP -> PRINTER
softkey.
1145.5973.12 1.17 E-6
To Next Page
Loading...
