Rohde & Schwarz FSH3 - Page 91

R&S FSH3 Setting the Sweep
¾ Change the video-trigger threshold with the cursor
keys or the rotary knob (0 to 100 %).
The trigger threshold is set immediately after entry.
¾ Terminate the trigger threshold entry with the
ENTER key or the TRIGGER softkey.
The value entry box is then closed.
¾ If a trigger delay is required, press the TRIGGER
softkey.
¾ Using the cursor keys or the rotary knob, select
DELAY... and confirm with the ENTER key or the
DELAY... softkey.
The delay value entry box is then opened.
¾ Using the number keys, the cursor keys or the
rotary knob, enter the delay and terminate the
entry with the ENTER key or the TRIGGER
softkey.
The trigger delay range is 0 µs to 100 s. The resolution
is 10 µs up to 1 ms and 100 µs from 1 ms to 10 ms.
The trigger delay resolution depends on the delay selected. The table below lists the values:
Trigger delay (DELAY) Resolution
0 to 1 ms 10 µs
1 ms to 10 ms 100 µs
10 ms to 100 ms 1 ms
100 ms to 1 s 10 ms
1 s to 10 s 100 ms
10 s to 100 s 1 s
1145.5973.12 4.17 E-6