Rohde & Schwarz FSW43 - Page 382

Common Measurement Settings
R&S
®
FSW
382User Manual 1173.9411.02 ─ 19
IF/VIDEO/DEMOD Output...........................................................................................382
IF (Wide) Out Frequency.............................................................................................383
Noise Source...............................................................................................................383
Trigger 2/3...................................................................................................................383
└ Output Type.................................................................................................. 383
└ Level................................................................................................... 384
└ Pulse Length.......................................................................................384
└ Send Trigger.......................................................................................384
IF/VIDEO/DEMOD Output
Defines the type of signal available at the IF/VIDEO/DEMOD or IF OUT connector on
the rear panel of the R&S FSW.
For restrictions and additional information see chapter 6.2.1.6, "IF and Video Signal
Output", on page 317.
"IF"
The measured IF value is available at the IF/VIDEO/DEMOD output
connector.
The frequency at which this value is available is defined in "IF (Wide)
Out Frequency" on page 383.
"IF 2 GHz Out"
The measured IF value is available at the IF OUT output connector at
a frequency of 2 GHz (with a bandwidth of 2 GHz).
This setting is only available for instrument models
R&S FSW43/50/67.
For further prerequisites see "IF 2 GHz Output" on page 318.
"VIDEO"
The displayed video signal (i.e. the filtered and detected IF signal) is
available at the IF/VIDEO/DEMOD output connector.
This setting is required to provide demodulated audio frequencies at
the output.
Remote command:
OUTPut:IF[:SOURce] on page 904
OUTPut:IF:SBANd? on page 905
Data Input and Output