Rohde & Schwarz FSW43 - Page 806

Remote Commands
R&S
®
FSW
806User Manual 1173.9411.02 ─ 19
Parameters:
<Time> Range: min value to max value
*RST: 1 s
Default unit: seconds
Manual operation: See "Dwell Time" on page 303
11.5.13.4 Configuring EMI Limit Lines
The commands required to define limit lines for EMI measurements are described in
chapter 11.8.4, "Configuring Display and Limit Lines", on page 975.
11.5.13.5 Controlling LISN
The commands required to control a LISN are described here.
INPut:LISN:PHASe.........................................................................................................806
INPut:LISN:FILTer:HPASs[:STATe] .................................................................................806
INPut:LISN:TYPE...........................................................................................................807
INPut:LISN:PHASe <Phase>
This command selects the phase of the LISN you want to measure.
Parameters:
<Phase> L1
L2
L3
N
*RST: L1
Example:
INP:LISN:PHAS N
Selects the N phase.
Manual operation: See "Phase" on page 305
INPut:LISN:FILTer:HPASs[:STATe] <State>
This command turns the 150 kHz highpass filter for the ENV216 network on and off.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
INP:LISN:HPAS ON
Turns the filter on.
Manual operation: See "150 kHz Highpass Filter" on page 305
Configuring and Performing Measurements