Rohde & Schwarz FSW43 - Page 883

Remote Commands
R&S
®
FSW
883User Manual 1173.9411.02 ─ 19
Usage: Query only
[SENSe:]PROBe<p>:SETup:TYPE?
Queries the type of the probe.
Suffix:
<p>
.
1 | 2 | 3
Selects the connector:
1 = Baseband Input I
2 = Baseband Input Q
3 = RF (currently not supported; use "1" with RF Input Connec-
tor setting "Baseband Input I")
Return values:
<Type> String containing one of the following values:
– None (no probe detected)
– active differential
– active single-ended
Usage: Query only
11.7.6.4 External Generator Control
External generator control commands are available if the R&S FSW External Genera-
tor Control option (R&S FSW-B10) is installed. For each measurement channel one
external generator can be configured. To switch between different configurations
define multiple measurement channels.
For more information on external generator control see chapter 6.2.4.2, "Basics on
External Generator Control", on page 331.
● Measurement Configuration..................................................................................883
● Interface Configuration..........................................................................................886
● Source Calibration.................................................................................................889
● Programming Example for External Generator Control........................................ 891
Measurement Configuration
The following commands are required to activate external generator control and to con-
figure a calibration measurement with an external tracking generator.
SOURce:EXTernal:FREQuency.......................................................................................884
SOURce:EXTernal:FREQuency:COUPling[:STATe].......................................................... 884
SOURce:EXTernal:FREQuency[:FACTor]:DENominator.................................................... 884
SOURce:EXTernal:FREQuency[:FACTor]:NUMerator........................................................885
SOURce:EXTernal:FREQuency:OFFSet.......................................................................... 885
SOURce:EXTernal:POWer[:LEVel].................................................................................. 886
SOURce:EXTernal[:STATe]............................................................................................ 886
SOURce:POWer[:LEVel][:IMMediate]:OFFSet...................................................................886
Setting Basic Measurement Parameters