Rohde & Schwarz FSW43 - Page 948

Remote Commands
R&S
®
FSW
948User Manual 1173.9411.02 ─ 19
Useful commands for spectrogram markers described elsewhere
The following commands define the horizontal position of the delta markers.
● CALCulate<n>:DELTamarker<m>:MAXimum:LEFT on page 940
● CALCulate<n>:DELTamarker<m>:MAXimum:NEXT on page 940
● CALCulate<n>:DELTamarker<m>:MAXimum[:PEAK] on page 940
● CALCulate<n>:DELTamarker<m>:MAXimum:RIGHt on page 940
● CALCulate<n>:DELTamarker<m>:MINimum:LEFT on page 941
● CALCulate<n>:DELTamarker<m>:MINimum:NEXT on page 941
● CALCulate<n>:DELTamarker<m>:MINimum[:PEAK] on page 941
● CALCulate<n>:DELTamarker<m>:MINimum:RIGHt on page 941
Remote commands exclusive to spectrogram markers
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:FRAMe...................................... 948
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:SARea....................................... 949
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:XY:MAXimum[:PEAK]..................949
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:XY:MINimum[:PEAK]...................949
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:Y:MAXimum:ABOVe....................949
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:Y:MAXimum:BELow.................... 949
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:Y:MAXimum:NEXT......................950
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:Y:MAXimum[:PEAK]....................950
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:Y:MINimum:ABOVe.....................950
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:Y:MINimum:BELow..................... 950
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:Y:MINimum:NEXT.......................951
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:Y:MINimum[:PEAK]..................... 951
CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:FRAMe <Frame> |
<Time>
This command positions a delta marker on a particular frame. The frame is relative to
the position of marker 1.
The command is available for the spectrogram.
Parameters:
<Frame> Selects a frame directly by the frame number. Valid if the time
stamp is off.
The range depends on the history depth.
<Time> Selects a frame via its time stamp. Valid if the time stamp is on.
The number is the distance to frame 0 in seconds. The range
depends on the history depth.
Example:
CALC:DELT4:SGR:FRAM -20
Sets fourth deltamarker 20 frames below marker 1.
CALC:DELT4:SGR:FRAM 2 s
Sets fourth deltamarker 2 seconds above the position of marker
1.
Analyzing Measurements (Basics)