At the time of purchase, the GR-30’s user patches
(A11 to d84) have been same content as preset patches
E11 to H84. These settings, as well as system settings
such as pickup sensitivity and MIDI channels for
sending and receiving, can be returned to the values
they had when the GR-30 was purchased.
<Restoring the Defaults (All Settings/Patches
Only/ System Settings Only)
1. If you wish to save the present settings, you can
either write down the settings or follow the steps
on p. 31 to back up the data on an external MIDI
instrument.
2. Switch off the power, then turn it back on while
holding down (depressing) pedal 2. The message
“PG#” flashes on the display.
3. Press [+] one to three times to select the item to be
returned to its default value (“PAt.” (“patch”:
patch content), “SyS.” (“system”: system-related
settings), or “ini.” (“initialize”: all settings).
4. Press [EDIT/PLAY]. The confirmation message
“Sur.” (“Are you sure?”) flashes on the display. If
you press [+] and [-] simultaneously at this point
to answer “yes,” the item selected in step 3 is
returned to its default value, and the message
“don.” (“done”) appears after a short pause.
✽
If “PAt.” of “ini.” is selected as the item to be initial-
ized, the display flashes “...” (three periods) several
times before showing “don.” (“done”). This means that
processing of the patch data is in progress, so do not
turn off the power until “don.” is displayed.
Recordering the Program
Change Numbers from the
Beginning
If you have repeatedly changed the original settings
for some patches and written these patches of your
own creation on the different patch numbers, or if
you have reordered the patches, the MIDI “PG
CHNG#” setting may become irregular and have no
connection with the patch-number sequence.
If it becomes necessary to again match these up with
the receiving-side Program Change numbers, which
are fixed in sequence from the beginning of the patch-
es, follow the steps below to reorder the sending
Program Change numbers from the starting patch.
✽
Please note that using this operation causes all "PG
CHNG#" settings for patches to be lost.
1. Switch off the power, then turn it back on while
holding down (depressing) pedal 2. The message
“PG#” flashes on the display.
2. Press [EDIT/PLAY]. The confirmation message
“Sur.” (“Are you sure?”) flashes on the display.
3. Press [+] and [-] simultaneously at this point to
answer “yes.” The sending Program Change num-
bers are reordered in sequence starting from the
first patch (1, 2, 3,..., 127, 128), and the message
“don.” (“done”) appears after a short pause. (All
Control Change No. 0 and No. 32 values are
returned to “0” for the sending Bank Select mes-
sages for user patches.)
Chapter 11: Other Convenient Functions
81
11
Restoring the Settings to Their Defaults (Initializing)
To Next Page
Loading...
