136
Detailed Settings for Each Function ([EDIT] Button)
3.
Press the Cursor [ ] [ ] buttons to select
“9.Utility.”
4.
Press the [ENTER] button to display the Edit
screen.
fig.05-29g
5.
Press the Cursor [ ] [ ] buttons to select
“2. Bulk Dump.”
6.
Press the [ENTER] button.
A screen like the one shown below appears.
fig.05-30g
7.
Put the external sequencer in record mode.
8.
Press the [ENTER] button to transmit the
settings.
The message “Now, Executing...” appears in the display
during transmission of the data.
After the transmitting is finished, the display will indicate
“Complete!.”
You are returned to the Edit screen.
9.
Stop the external sequencer.
The settings stored in the RD-700GX can be returned to their
factory settings.
Executing “Factory Reset All” results in deletion of
the Setups
(p. 65).
If you want to keep the recorded
content, save the Setup file to your USB memory
(p.
120).
When making USB connections, be absolutely sure
to disconnect the USB cable before starting.
1.
Press the [EDIT] button, getting the indicator to
light.
The Edit Menu screen appears.
2.
Press the Cursor [ ] button to select
“9.Utility.”
3.
Press the [ENTER] button to display the Edit
screen.
fig.05-35g
4.
Press the Cursor [ ] [ ] buttons to select
“3. Factory Reset Curnt” or “4. Factory Reset
All.”
While the Factory Reset is in progress, no sounds
are produced even when the keys are pressed. In
addition, Rhythms and arpeggios being played
are also stopped.
Restoring the Settings to the Factory
Condition (Factory Reset)
Parameter
Value
Factory Reset Curnt
(Factory Reset
Current)
The currently selected Setup returned to
their factory settings.
Factory Reset All
The settings stored in the RD-700GX can
be returned to their factory settings.
NOTE
NOTE
NOTE
RD-700GX_e.book 136 ページ ２００８年２月１３日 水曜日 午後５時４９分
To Next Page
Loading...
Need help?
General
