Roland RD-700GX - Changing the Tone for a Zone

45
Performance
fig.Q1-20p
1.
Press the [EXIT/SHIFT] button several times to access the Tone screen.
2.
Use the Cursor [ ] [ ] buttons to select the zone whose tone you want to change.
3.
Use the TONE SELECT buttons to select the tone category, and then use the [DEC] [INC]
buttons or the VALUE dial to select a tone.
When the [NUM LOCK] button is on, you can specify tone numbers with the TONE SELECT buttons
(p. 37). After using the TONE SELECT buttons to specify the tone number, press the [ENTER] button
to finalize your choice.
If you press the [ ] [ ] buttons to select a zone whose ZONE SWITCH is off
(unlit), the ZONE SWITCH of the selected zone and the [ENTER] button will blink.
Pressing any of these flashing buttons then sets that zone’s ZONE SWITCH to ON
(lit).
Changing the Tone for a Zone
RD-700GX_e.book 45 ページ ２００８年２月１３日 水曜日 午後５時４９分