27
Advanced Use
■ Parameter List
* Rim sensitivity is active when is selected as the input mode.
This is disabled (—) when anything other than or is selected for the trigger
type.
Threshold
0–15
This setting allows a trigger signal to be
received only when the pad is struck harder
than a specified force. This can be used to
prevent a pad from sounding in response to
extraneous vibrations from another pad. In
the following example, B will sound but A
and C will not sound.
fig.05-10_80
When set to a higher value, no sound is
produced when the pad is struck lightly.
Gradually raise the Threshold value while
striking the pad. Check this and adjust
accordingly. Repeat this process until you
get the perfect setting for your playing style.
Sensitivity
1–16
Same value as PAD SENS. (p. 17)
Velocity Curve
This sets the way the volume changes in
accordance with how strongly the pad is
struck.
(Linear)
This is the normal setting. This produces the
most natural correspondence between the
strength of the strike and the change in
volume.
fig.05-11_80
Parameter Value
Input Mode
(displayed when turning on the power)
Head x 2
Head & Rim
Trigger Type RP-2
PD-80/100
PD-80R
PD-120
PD-5/6/7/9
KD-7/80/120
Threshold
0–15
Sensitivity
1–16
Velocity Curve , , , , ,
, ,
Scan Time
0–4.0 ms
(adjustable in increments of 0.1 ms)
Retrigger Cancel
1–16
Crosstalk Cancel
, 20–80
(adjustable in increments of 5)
Mask Time
0–64 ms
(adjustable in increments of 4 ms)
Rim Sensitivity*
, 1–20 (or —)
Threshold
CBA
Volume
Striking Force
LINEAR
To Next Page
Loading...
