EasyManua.ls Logo

Roland SP-404MK - Editing Effects

Roland SP-404MK
204 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UsingtheEffects
EditingtheEffects
Whenyoupressaneffectbutton(suchasthe[FILTER+DRIVE]button)toturntheeffecton,theeffecteditscreen
appears.
Turnthe[CTRL1]‒[CTRL3]knobswhiletheeffecteditscreenisdisplayedtoeditthemainparametersoftheeffect.
Youmaybeabletoaccessthesub-parametersbyholdingdownthe[VALUE]knob,dependingontheeffect.Turnthe
[CTRL1]‒[CTRL3]knobstoeditthesub-parametersoftheeffect.
Lockingtheeffecteditscreen
Althoughtheeffecteditscreendisplayswhenyoupressaneffectbutton,thescreennormallyreturnstotheprevious
screenifyoudonʼtoperateanycontrolsforseveralseconds.
Youcanusethefollowingoperationifyouwanttomaketheeffecteditscreenkeepdisplaying.
Abouttheeffectparametersavespecificationsandsharing
ThemainparametersoftheeffectsassignedtoBUS1andBUS2arerestoredtotheirdefaultvalueswhenyouturnoff
thepower(inotherwords,anychangesarenotsaved).
Parametersthatareretainedevenafteryouturnoffthepowerofthisunitareshownbelow.
Bustowhicheffectsareassigned Mainparameters Sub-parameters
INPUT(INPUTFX) µ µ
BUS1 (Notsaved)
BUS2
BUS3 µ µ
BUS4
Theeffectparametersonthisunitaresharedincommonwithsomebusestowhicheffectsareassigned.
Forinstance,thesub-parametersofeffectsassignedtoINPUT,BUS1andBUS2aresharedincommon.Forthis
reason,whenyouassignthesameeffecttoINPUTandBUS1andthenchangetheINPUTFXsub-parameters,theBUS
1sub-parametersbecomethesamevalues.
TheeffectparametersarelikewisesharedbetweenBUS3andBUS4aswell.
Whileholdingdownthe[REMAIN]button,pressaneffectbutton(suchasthe[FILTER+DRIVE]button).
Theeffecteditscreenappears.Evenifyoudonʼtoperatetheunitforawhileafterthis,theunitdoesnot
returntothepreviousscreen.
Thedisplayswitchesbetweenmainparametersandsub-parameterseachtimeyoupressthe[VALUE]
knob,dependingontheeffect.
1
Tofinishmakingsetting,pressthe[EXIT]buttonorthe[REMAIN]button.
2

Related product manuals