Roland SP-404MK - Using Batteries

Introduction > GettingThingsReady > AboutthePowerSupply
UsingBatteries
Beforeinstalling/removingbatteries,makesuretoturnoffthepowertothisunitanddisconnectallconnectionsto
otherdevices.
Whenturningtheunitover,becarefulsoastoprotectthebuttonsandknobsfromdamage.Also,handletheunit
carefully;donotdropit.
Removethebatterycompartmentcoverlocatedonthebottomofthisunit,andinsertthebatteriesinthecorrect
polarity(direction)asmarkedinsidethebatterycompartment.
Closethecoversecurely.
ThisunitusessixAAbatteries(rechargeableNi-MHoralkaline).
Theunitcanrunfor3.5hoursonrechargeableNi-MHbatteries(1,900mAh),andfor2.5hoursonalkalinebatteries.
(Notethatthesetimesmaydifferdependingontheconditionsofuseandofthebatteries.)
Ifyouhandlebatteriesimproperly,youriskexplosionandfluidleakage.Makesurethatyoucarefullyobserveallofthe
itemsrelatedtobatteriesthatarelistedinleaflet“ReadMeFirst”(USINGTHEUNITSAFELY.)