Roland SP-404MK - Resampling a Sample

Sampling(SAMPLING)
ResamplingaSample(RESAMPLE)
Resamplingmeanssamplingasampleitselfwhileitʼsplayingback.Youcansamplethesoundofasampletowhich
effectsareapplied,orsamplethesoundofmultiplesamplesthatareplayingbackatthesametime,creatingasingle
sample.
Also,byturningthepatternsequenceronbeforehand(the[PATTERNSELECT]buttonlightsup),youcanresamplea
patterninthesamewayasyouwouldresampleasample.
Pressthe[RESAMPLE]button.
Themetronomesoundswhenthe“Metronome:REC”parameteris“ON”(theSYSTEMparameter“CLICK”).
Presspad[9]whileholdingdownthe[SHIFT]buttontoturnthemetronomesoundon/off.
1
Pressthe[RECORDSETTING]button.
Theinputsettingscreenappears.
2
Usethe[CTRL2]knobtosetROUTINGto“Mix.”
WhenROUTINGissetto“ExtIn,”onlytheaudioinputfromanexternaldeviceissampled(thesampleʼs
audioisnotincludedintheresample).Youcansampleyourperformancewhileplayingbacksamplesas
backingsounds.
3
Usethe[CTRL1]knobtoadjustthetempoduringsampling(thesampletempo),andusethe[CTRL
3]knobtoadjustthevolumeofaudioinputfromanexternaldevice.
4
Pressthe[EXIT]buttonorthe[RESAMPLE]button.
5
Presspads[1]‒[16]thatareblinkingred.
Theemptypadstowhichsampleshavenʼtbeenassignedblinkred.
Whenyoupressanemptypad,thepadlightsuporange,andamessage“PressPadtoSTART”isshown.
6