Roland SP-404MK - Adding Count-in Before Sampling

Sampling(SAMPLING) > Sampling
AddingaCount-inBeforeSampling
Thisfeatureaddsacount-inbeforesamplingbegins.Thisgivesyoutimetogetreadytoplaybeforesamplingactually
begins.
Holddownthe[SHIFT]buttonandpressthepad[10].
Thevaluechangesinordereachtimeyoupresspad[10]whileholdingdownthe[SHIFT]button.
Editthecount-insetting.
Value Explanation
COUNTIN
1MEAS
Addsaone-measurecount-inbeforesampling.
COUNTIN
2MEAS
Addsatwo-measurecount-inbeforesampling.
COUNTIN
WAIT
WhentheinputaudiosignalexceedsthelevelsetintheAutoTrigLevelparameter,
samplingbegins.
COUNTIN
OFF
Nocount-inisused.Samplingstartsimmediatelyafteryoupressthepads[1]‒[16]to
sampleandthenpressthe[REC]button.
1