Roland SP-404MK - Resampling a Pattern

CombiningSamplestoCreateaPattern(PATTERNSEQUENCER)
ResamplingaPattern(RESAMPLE)
Youcanresampletheperformanceyourecordedtoapattern,andturnitintoasample.
Pressthe[PATTERNSELECT]button.
1
Pressthe[RESAMPLE]button.
Themetronomesoundswhenthe“Metronome:REC”parameteris“ON”(theSYSTEMparameter“CLICK”).
Presspad[9]whileholdingdownthe[SHIFT]buttontoturnthemetronomesoundon/off.
2
Pressthe[RECORDSETTING]button.
Theinputsettingscreenappears.
3
Usethe[CTRL2]knobtosetROUTINGto“Mix.”
WhenROUTINGissetto“ExtIn,”onlytheaudioinputfromanexternaldeviceissampled(thesampleʼs
audioisnotincludedintheresample).Youcansampleyourperformancewhileplayingbacksamplesas
backingsounds.
4
Pressthe[EXIT]button.
5
Pressthepads[1]‒[16]thatareblinkingred.
Emptypadstowhichsampleshavenʼtbeenassignedblinkred.
Whenyoupressanemptypad,themessage“PressPadtoSTART”isshown.Padsthatcontaina
recordedpatternblinkinblue.
6
Presspads[1]‒[16]toselectapattern.
Samplingbeginswhenthepatternstartsplayingback.
7