Roland TAIKO-1 - Applying Ambience to the Entire Kit (Ambience); Applying MFX to each Pad (MFX)

Editing Sounds and Other Settings for Kits (Kit Edit)
19
Applying Ambience to the Entire Kit (Ambience)
Here’s how to apply ambience to a kit.
1. On the EFFECTS screen, select “Ambience” and then
press “SELECT” (F2 button).
The AMBIENCE screen appears.
2. Strike to select the pad that you want to set.
3. Use the [
H
] [
I
] buttons to select the item, and then
use the [+] [-] buttons to change the setting.
Parameter
[
H
] [
I
] buttons
Value
[+] [-] buttons
Explanation
Ambience Sw OFF, ON Turns the ambience on/o.
Level
-INF, -60.0–+12.0
[dB] (in units
of 0.5)
Adjusts the reverberation volume.
Type TYPE 1–5 Sets the type of reverberation.
Width 0–9 Adjusts the ambience spread.
Low Gain -15–+15 [dB]
Adjusts the boost/cut of the low frequency
range.
High Gain -15–+15 [dB]
Adjusts the boost/cut of the high frequency
range.
4. Press “AMB SEND” (F2 button).
The AMBIENCE SEND screen appears.
5. Use the [
H
] [
I
] buttons to select the item, and then
use the [+] [-] buttons to change the setting.
Parameter
[
H
] [
I
] buttons
Value
[+] [-] buttons
Explanation
PAD1H
-INF,
-60.0–+6.0 [dB] (in
units of 0.5)
These parameters adjust how much
ambience is applied to each pad.
PAD1R
PAD2H
PAD2R
6. Press the F1 button several times to return to the top
screen.
Applying MFX to Each Pad (MFX)
Here’s how to apply a multi-eect (MFX) to each pad.
1. On the EFFECTS screen, select “MFX” and then press
“SELECT” (F2 button).
The MFX screen appears.
2. Strike to select the pad that you want to set.
3. Use the [
H
] [
I
] buttons to select the item, and then
use the [+] [-] buttons to change the setting.
Parameter
[
H
] [
I
] buttons
Value
[+] [-] buttons
Explanation
Pad PAD1H–PAD2R Selects the pad to set.
MFX Assign
OFF,
MFX1–3
Selects the multi-eect that is applied for
each pad.
Send Level
-INF, -60.0–+6.0
[dB] (in units of
0.5)
Adjusts the amount of eect applied for
each pad.
Wet Only Sw
Wet Only Only the eect sound is output.
Dry+Wet
The dry sound and eect sound are both
output.
4. Press “MFX1” (F2 button) to edit the MFX.
Use the F1 and F2 button to select MFX1–3.
MFX1 screen
MFX2 screen MFX3 screen
F1
F2
F1
F2
5. Use the [
H
] [
I
] buttons to select the item, and then
use the [+] [-] buttons to change the setting.
The eect changes when you change the TYPE.
&
For details on the MFX parameters, refer to “MFX List” (p. 45).
6. Press the F1 button several times to return to the top
screen.