Roland TAIKO-1 - Loading Backup Data; Load Backup

Backing up to USB Flash Drive (USB Memory)
34
Loading Backup Data (Load Backup)
This imports the backup data from a USB ash drive.
1. On the USB MEMORY screen, select “Load Backup”
and then press “SELECT” (F2 button).
The LOAD BACKUP screen appears.
Parameter
[
H
] [
I
] buttons
Explanation
All All settings (backup data) are loaded.
1 Kit Only one kit (kit backup data) is loaded.
Loading All Kits (LOAD BACKUP ALL)
2. On the LOAD BACKUP screen, select “All” and then
press “SELECT” (F2 button).
“ - Src (USB memory) - ” appears.
Backup lename
When you select the bank number in which data is
saved, the corresponding lename is shown.
With User Sample
When user samples are included in the backup
data, a check box labeled “With User Sample” is
shown below the bank number to save.
Bank number
MEMO
5 When you load user samples, the user samples included in the backup data are
overwritten onto the user samples in user memory.
5 Depending on the size of the user samples, it might take ten minutes or more to
load the data.
3. Use the [+] [–] buttons to select the data to load, and
then press “EXECUTE” (F2 button).
A conrmation message appears.
If you decide to cancel, press “CANCEL” (F1 button).
4. To execute, press the [+] button.
5. Press the F1 button several times to return to the top
screen.
Loading Only One Kit (LOAD BACKUP 1 KIT)
2. On the LOAD BACKUP screen, select “1 Kit” and then
press “SELECT” (F2 button).
“ - Src (USB memory) - ” appears.
Kit name
When you select the bank number in which data is
saved, the kit name is shown.
With User Sample
When user samples are included in the kit backup
data, a check box labeled “With User Sample” is
shown below the kit number to save.
Bank number
3. Use the [+] [–] buttons to select the kit to load, and
then press “NEXT” (F2 button).
“ - Dest (Internal) - ” appears.
4. Use the [+] [–] buttons to select the load destination.
A conrmation message appears.
If you decide to cancel, press “CANCEL” (F1 button).
5. To execute, press the [+] button.