Roland TAIKO-1 - MFX List

Appendix
45
MFX List
DELAY 40
TAPE ECHO 40
REVERSE DELAY 41
3TAP PAN DELAY 41
SHELL RESONANCE 41
OD
0
DELAY 41
DS
0
DELAY 41
CHORUS 42
SPACE-D 42
OD
0
CHORUS 42
DS
0
CHORUS 42
PHASER 1 42
PHASER 3 43
STEP PHASER 43
FLANGER 43
REVERB 43
LONG REVERB 44
SUPER FILTER 44
FILTER+DRIVE 45
AUTO WAH 45
OD/DS
0
TWAH 45
LOFI COMPRESS 45
DISTORTION 46
OVERDRIVE 46
SATURATOR 46
T-SCREAM 46
BIT CRUSHER 46
ISOLATOR 46
PITCH SHIFTER 47
AUTO PAN 47
DELAY
This is a stereo delay.
Parameter Value Explanation
Tempo Sync
Left, Right
OFF, ON
Sets whether the delay time value of the left/
right delay sounds is specied as a note value
(ON) or not (OFF).
Delay Left,
Right Time
1–1300 [msec],
note
Delay time from the original sound until the
left/right delay sound is heard
Phase Left,
Right
NORMAL, INVERSE
Phase of the left/right delay sound
NORMAL: not inverted
INVERSE: inverted
Feedback
Mode
NORMAL, CROSS
Input destination fed back into the delay
sound
NORMAL: The left/right delay sound is fed
back as-is.
CROSS: The left/right delay sounds are
alternately fed back.
Feedback -98–+98 [%]
The amount of delay sound fed back to the
input.
(Negative values invert the phase.)
HF Damp
200–8000
Hz, BYPASS
Center frequency at which the high
frequencies of the delay sound fed back to the
input are cut
(set this to BYPASS if you do not want to cut
the frequencies)
Low Gain -15–+15 [dB] Amount of low range boost/cut
High Gain -15–+15 [dB] Amount of high range boost/cut
Level 0–127 Output level
TAPE ECHO
A virtual tape echo that produces a realistic tape delay sound. This
simulates the tape echo section of a Roland RE-201 Space Echo.
Parameter Value Explanation
Mode
S, M, L, S+M, S+L,
M+L, S+M+L
The combination of playback heads to use.
Select from three dierent heads with dierent
delay times.
S: short
M: middle
L: long
Repeat Rate 0–127
Tape speed
Increasing this value shortens the spacing of
the delayed sound.
Intensity 0–127 Amount of delay repeats
Bass -15–+15 [dB]
Boost/cut for the lower range of the echo
sound
Treble -15–+15 [dB]
Boost/cut for the upper range of the echo
sound
Head S Pan L64–R63
Stereo position of each head for short/middle/
long playback
Head M Pan L64–R63
Head L Pan L64–R63
Tape Distortion 0–5
Amount of tape-dependent distortion to be
added.
This simulates the slight tonal changes that
can be detected by signal-analysis equipment.
Increase this value for more distortion.
W/F Rate 0–127
Speed of wow/utter (complex variation in
pitch caused by tape wear and rotational
irregularity)
W/F Depth 0–127 Depth of wow/utter
Level 0–127 Output level