Roland TAIKO-1 - Rear Panel (Connecting Your Equipment)

Panel Descriptions
9
A
OUTPUT jack (mono)
Outputs the sound. Connect this to your
amplied speaker or mixer.
As necessary, use the cable clamp to tie the cable
to the rod.
B
FOOT SW jack
You can connect a footswitch (BOSS FS-5U, FS-
6; sold separately) and use it to control various parameters.
&
“Conguring the Pedal Jacks and Shortcut Settings (Control
Settings)” (p. 36)
Factory settings:
You can use FOOT SW 1/2 to step forward or backward through the kits, one
at a time.
C
EXP PEDAL 1/2 jacks
You can connect an expression pedal (EV-5, sold separately) and
use it to control various parameters.
&
“Conguring the Pedal Jacks and Shortcut Settings (Control
Settings)” (p. 36)
Factory settings:
You can use EXP PEDAL 1 to control the overall volume.
You can use EXP PEDAL 2 to control the volume of the “ji-uchi” (base beat).
* Use only the specied expression pedal. Connecting any other expression
pedals may cause the unit to malfunction or become damaged.
D
TRIG IN 1 jack
Use the included trigger cable to connect the TRIG OUT jack of pad
1 to the TRIG IN 1 jack.
E
TRIG IN 2 jack
Use the included trigger cable to connect the TRIG OUT jack of pad
2 to the TRIG IN 2 jack.
F
DC IN jack
Connect the included AC adaptor to this jack.
* Use the cord hook to secure the cord of the AC adaptor as shown in the
illustration.
G
Batteries
&
“Installing the Batteries” (p. 10)
H
PHONES jack
Connect your headphones here. Use a stereo mini plug for this
connection.
* Even if headphones are connected, sound is still output from the OUTPUT
jack.
I
MIX IN jack
Connect an external audio device.
Use a stereo mini plug for this connection.
J
USB COMPUTER port
Connect your computer to the TAIKO-1’s USB port via USB cable.
* Do not use a micro USB cable that is designed only for charging a device.
Cables used for charging only cannot transmit data.
K
USB MEMORY port
You can connect a USB ash drive here.
&
“Backing up to USB Flash Drive (USB Memory)” (p. 33)
* Never turn o the power or remove the USB ash drive while the message
“Processing...” is displayed.
Cable clamps
Rear Panel (Connecting Your Equipment)
* To prevent malfunction and equipment failure, always turn down the volume, and turn o all the units before making any connections.
G
Batteries
&
“Installing the Batteries” (p. 10)
F
DC IN jack
Connect the included AC adaptor to
this jack.
E
TRIG IN 2 jack
H
PHONES jack
I
MIX IN jack
Connect an audio device
here.
A
OUTPUT jack
B
FOOT SW jack
C
EXP PEDAL 1/2 jacks
J
USB COMPUTER port
K
USB MEMORY port
D
TRIG IN 1 jack
’
to AC outlet
AC adaptor
Pad 2 Pad 1
Cord hook