Roland V-Drums TD-50 - REVERB (Page 3); STEREO ENHANCER (Page 4)

12
KIT CUSTOMIZE
REVERB (page 3)
Parameter Value Explanation
[F4] button OFF, REV ON Turns reverb on/o.
ROOM tab
Type ([R1] knob) ROOM 1, 2, HALL 1, 2, PLATE Type of reverb
Level ([R2] knob) -INF–+6.0 dB Volume of reverb
Pre Delay 0–100 mSec Adjusts the delay time from the direct sound until the reverb sound is heard
Time 0.1–10.0 Sec Time length of reverberation
Density 0–127 Density of reverb sound
Diusion 0–127
Change in the density of the reverb sound over time
The higher the value, the denser the sound becomes as time elapses (The eect is more obvious for
longer reverb times).
LF Damp 0–100 Adjusts the low-frequency region of the reverb sound.
HF Damp 0–100 Adjusts the high-frequency region of the reverb sound.
Spread 0–127 Spread of the reverb sound
Tone 0–127 Tonal character of reverb sound
SEND tab
Reverb Send Volume -INF–+6.0 dB
Amount of reverb applied to each pad
If you press the [F5] (H&R) button to turn it “ON,” you can simultaneously make settings for the head
area and rim area, etc.
STEREO ENHANCER (page 4)
Parameter Value Explanation
[F4] button OFF, ENHNC ON Turns stereo enhancer on/o.
ROOM tab
Width ([R1] knob) MONO, 1–4 Spread of stereo enhancer
Level ([R2] knob) -INF–+6.0 dB Volume of stereo enhancer
Color 1–6 Tonal character of stereo enhancer
MAIN SEND tab
Stereo Enhancer Main Inst Send -INF–+6.0 dB
Amount of stereo enhancer applied to each pad (main instrument)
If you press the [F5] (H&R) button to turn it “ON,” you can simultaneously make settings for the head
area and rim area, etc.
SUB SEND tab
Stereo Enhancer Sub Inst Send -INF–+6.0 dB
Amount of stereo enhancer applied to each pad (sub-instrument)
If you press the [F5] (H&R) button to turn it “ON,” you can simultaneously make settings for the head
area and rim area, etc.