Roland V-Drums TD-50 - Multi-Effect Parameters

34
Multi-Eect Parameters
The multi-eects feature 30 dierent kinds of eects. Some of the eects consist of two or more dierent eects connected in series.
Eect type Page
DELAY p. 35
TAPE ECHO p. 35
REVERSE DELAY p. 35
3TAP PAN DELAY p. 35
OD
0
DELAY
p. 36
DS
0
DELAY
p. 36
CHORUS p. 36
SPACE-D p. 36
OD
0
CHORUS
p. 36
DS
0
CHORUS
p. 36
PHASER A p. 37
PHASER B p. 37
STEP PHASER p. 37
FLANGER p. 37
REVERB p. 38
LONG REVERB p. 38
SUPER FILTER p. 38
FILTER+DRIVE p. 38
AUTO WAH p. 39
OD/DS
0
TWAH
p. 39
LOFI COMPRESS p. 39
DISTORTION p. 39
OVERDRIVE p. 39
SATURATOR p. 39
T-SCREAM p. 40
BIT CRUSHER p. 40
ISOLATOR p. 40
RING MODULATOR p. 40
PITCH SHIFTER p. 40
AUTO PAN p. 40
About note values
Some eect parameters (such as Rate or Delay Time) can be set by using note values.
Sixty-fourth-note triplet Sixty-fourth note Thirty-second-note triplet Thirty-second note
Sixteenth-note triplet Dotted thirty-second note Sixteenth note Eighth-note triplet
Dotted sixteenth note Eighth note Quarter-note triplet Dotted eighth note
Quarter note Half-note triplet Dotted quarter note Half note
Whole-note triplet Dotted half note Whole note Double-note triplet
Dotted whole note Double note
NOTE
If you set the delay time as a note value, slowing down the tempo will not change the delay time beyond a certain length. There is an upper limit
for the delay time so if it is set as a note value and you slow down the tempo until this upper limit is reached, the delay time cannot change any
further. This upper limit is the maximum value that can be specied when setting the delay time as a numerical value.