Roland V-Drums TD-50 - Ambience and Mixer Settings; Adjusting Room Ambience and Reverb; Editing Pad Mixer Settings

18
USER SAMPLE
SAMPLE LIST
Parameter Value Explanation
[F5] button
Renames the currently selected user sample.
Reference
For details on how to assign a name, refer to “Renaming a Drum Kit” in “Reference Manual” (PDF).
LIST tab
Play Type
Species how the user sample is sounded.
ONESHOT MONO
When you strike the pad, the currently-heard sound is silenced before the new sound is heard.
Notes do not overlap.
ONESHOT POLY When you strike the pad repeatedly, the sounds of the notes are heard overlapping.
LOOP ALT
The user sample plays repeatedly (loop).
Each time you strike the pad, the sound alternately plays or stops.
START/END tab
Zoom ([R1] knob) –
Zooms the waveform display in or out.
You can zoom-in/out on the horizontal axis by turning the [R1] knob or by holding down the
[SHIFT] button and pressing the cursor [
K
] [
J
] buttons.
If you hold down the [SHIFT] button and turn the [R1] knob or use the cursor [
H
] [
I
] buttons, you’ll
zoom-in/out on the vertical axis.
Start ([R2] knob)*1 0–07937742 Adjusts the start point (the location at which the user sample starts playing).
End ([R3] knob)*1 257–07937999 Adjusts the end point (the location at which the user sample stops playing).
*1 You can’t set the end point earlier than the start point.
You can’t set the start point and end point to the same value.
For both the start point and end point, you can’t specify a value that exceeds the length of the user sample.