Roland VersaStudio BN-20 - Aligning Automatically and Cutting

Performing Printing and Cutting Separately
Chapter 2 Fully Utilizing the Machine
37
Chapter 2 Fully Utilizing the Machine
Aligning Automatically and Cutting
This section describes how to make settings when using the BN-20 driver. When using Roland VersaWorks,
refer to the "Roland VersaWorks Quick Start Guide".
Procedure

Print with a crop mark, and then reload the media that was removed.
 P. 35, “Printing with Crop Marks”
Points for Media Setting
Place the crop marks on the blade protector.
Angled no more than 5 degrees. Otherwise alignment becomes impossible.
Set to 5° or less.
Crop marks
Blade protector