CARING FOR YOUR RANGE
Cooktop light replacement
(on models with fluorescent light)
The cooktop light is in the top of the control
console. The switch is on the control console.
Push the switch to turn the light on. The light
may take a few seconds to light up.
Electrical Shock Hazard
l
Make sure power to the range has been
turned OFF at the main power supply
before replacing the fluorescent tube.
l
Failure to do so could result in electrical
shock.
To replace the fluorescent light tube:
1. Turn power off.
2. Lift the cover on top of the control console
by lifting the front edge at both ends.
3. Grasp the fluorescent tube at both ends.
4. Turn the tube 90 degrees and lift out of the
receptacle.
5. Replace with an Fl 8T8 type fluorescent tube.
6. Rotate the tube back by 90 degrees to the
original position.
REPLACING LIGHT BULBS
& RESETTING BREAKERS
Oven light replacement
The oven light will come on when you open the
oven door.
To turn the light on when the oven door is
closed, push the oven light switch on the
control console. Push the switch again to turn
off the light.
Electrical Shock and Personal
Injury
Hazard
l
Make sure oven and light bulb are
cool and power to the range has been
turned off before replacing the light
bulb. Failure to do so could result in
electrical shock or burns.
l
The bulb cover must be in place when
using the oven. The cover protects the
bulb from breaking, and from high oven
temperatures. Because the bulb cover
is made of glass, be careful not to drop
it. Broken glass could cause injury.
To replace the oven light:
1, Unplug appliance or disconnect at the main
power supply.
39
To Next Page
Loading...