Programming Instructions
AC-015 Hardware Installation and Programming Manual 27
3. Enter the new 4-digit code you wish to set
as Lock Strike Code 1.
You hear three beeps.
The system returns to Normal mode.
10.4 Changing Lock Strike Code 2
The Lock Strike Code 2 is mainly used as a method to quickly test the
Lock Strike Relay during installation.
There is no default code for Lock Strike Code 2.
To change Lock Strike Code 2:
1. Enter Programming mode.
2. Press 2.
The Door LED remains green.
The Mode LED turns orange.
3. Enter the new 4-digit code you wish to set
as Lock Strike Code 1.
You hear three beeps.
The system returns to Normal mode.
10.5 Changing the Programming Code
To change the Programming code:
1. Enter Programming mode.
2. Press 3.
The Door LED remains green.
The Mode LED turns green.
To Next Page
Loading...
