Programming Instructions
AC-015 Hardware Installation and Programming Manual 35
3. Reconnect power to the unit with the REX button pressed.
4. Release the REX button.
5. You now have 20 seconds to program a new Programming code
into the controller using the initial default code (1234) before the
controller reverts to the existing code.
10.14 Replacing Lost Normal/Secure Code
In the event that your Normal or Secure code is lost and you are
locked in Secure mode, perform the following procedure to re-enter
Normal mode so that you may program a new Normal/Secure code.
The AC-015 must be in Secure mode or this procedure does not
work.
Make sure that the Mode LED is red before proceeding.
1. Disconnect power from the AC-015.
2. Press the REX button.
3. Reconnect power to the unit with the REX button pressed.
4. Release the REX button.
5. You now have 20 seconds to enter the default Secure code
(3838) to return the system to Normal mode.