Programming Instructions
30 AC-015 Hardware Installation and Programming Manual
First Digit
For fail secure operation, the first digit
is set to 0.
For failsafe operation, the first digit is
set to 1.
Second Digit
If the Tamper Alarm is required, enter
1–9 as the second digit to set the
alarm sound time from a minute to 9
minutes.
If the Tamper Alarm is not required,
enter 0 as the second digit.
Third and Fourth Digits
The number of seconds you wish the
door release to remain activated. The
default door open time is 4 seconds.
For example 0 5 1 2 means: fail secure with a 5-minute tamper
alarm sound time and a 12-second door release.
You hear three beeps.
The system returns to Normal mode.
10.9 Enrolling Proximity Cards/Tags and
Keyboard Codes into the System
Each proximity card is unique and can only be assigned to one slot at
a time. If an unassigned proximity card is enrolled at an occupied slot,
the AC-015 generates a long beep and waits for another slot number
to be entered. The card at the current slot location must be erased
before a new code is programmed on that slot number. The same
rules apply for PIN-based employee codes.
To Next Page
Loading...
Need help?
General
