Introduction
8 AC-015 Hardware Installation and Programming Manual
1. Introduction
The AC-015 Single-Door Access Control Programmer allows you to
add or delete employees from the system, change system mode status
and change system authorization codes.
The AC-015 provides a higher level of security as the programmer is
normally placed in a secure location while the reader sensor is
remotely located outside the premises to be controlled. Should the
remote sensor be attacked, entry cannot be gained as the remote
sensor only provides data to the programmer, not authorization to
release the controlled door.
The system may be connected with the optional PC monitor program
for easier management of the employee database or for online
monitoring of door access. The system is linked to a PC via RS-232
serial link. The PC receives information from the AC-015, which is
displayed and saved to a database.
Codes entries and their consequences are visible in Online mode of
the software. The Employees menu is used to describe, enter and
associate employee code numbers with employee name and details.
Programming menu is used to define door details, working days and
holiday definitions. Reports menu specifies which kind of report to
build. Options menu is used for communication setup, language
setup, operator’s password and database status. For more details
refer to the AC-015 Monitor Program Manual. The AC-015 accepts
up to 500 employees via the use of proximity cards (provided
separately) or PIN codes into the system. Each employee is issued a
unique proximity card or PIN code.
Employees designated 01 to 10 are Master Users and can operate the
system in both the Normal and Secure modes of operation.
Employees 11 to 500, when entered from the external reader sensor,
may only operate the system in both the Normal and Bypass modes of
operation.
It is very important to keep an accurate record of the slot number and
its assignment to each employee. This is to enable you to add
To Next Page
Loading...
Need help?
General
