Operator`s Manual RM1
Seite/page 72/132 ROTAX KART RM1 Ausgabe/Edition 01/2006
Note: If the CIK-front bumper is fitted, the shield can no longer be fitted to the front fender.
¨ Drill a hole of 6.5 mm (0.26 in.) in the front shield.
¨ Fix the front shield with a screw M6x20, a shim
and a securing nut on the CIK-front bumper.
Note: If you wish to use the CIK-front bumper permanently on your vehicle, you can
remove the two fixation brackets (Pos. 1) from the front shield.
1.1.4. Rear fender system (RFS)
The rear fender system consisting of 4 fenders
connected with 2 plastic tubes create a straight
line run-up surface. These parts are elastic
and thus can avoid damages (according to the
crash tests prescribed by CIK – FIA).
1.1.5. Rear tire protection system (RTPS)
The rear tire protection system was developed by
ROTAX especially for application on the RM1
Kart and patented. This new rear tire protection
system can prevent many of the injuries and
damage caused by driving over the rear wheel of
the preceding Kart.
The 2 rotatable rollers behind the right and left
rear wheel prevent the “climbing” of the
following vehicle.
To Next Page
Loading...