42
TRANSACTION NUMBER PRESET
Transaction Number Preset allows you to choose a beginning transaction number of your own. The Transaction
Number normally begins with the number 0001 and counts up consecutively until a "Z" Report is taken; thereafter it
resets back to 0001. Transaction Number Preset can also be used to re-enter the last transaction number in the
event information is lost.
Extra Option: The register is programmed not to have the Transaction Number reset to zero after a "Z" Report is
taken. If desired, a procedure is offered to have the Transaction Number reset to zero after a "Z"
Report is taken. See Flag 15, on Page 60.
TO PROGRAM THE TRANSACTION NUMBER
"PRG" + (1) + (TRANSACTION #) + [PO]
4 digit # (in range 0000 -9999)
Example: To program the Transaction Number to be 1000:
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the [CLERK]
key, or if you did not program a Manager Password, go to Step 3.
3. ENTER (1), (1000), then PRESS the [PO] key.
To Next Page
Loading...
