Ruida Technology RDV6442G - Page 23

RDV6442G Control System manual V1.3
SHENZHEN RUIDA TECHNOLOGY
16
low-level form, this pin will be connected with the laser power enable
end and used to control the ON/Off of laser.
3
LPWM1
Power control interface of laser/laser tube
1. When the laser is the RF laser, this pin will be connected with the laser
RF-PWM end;
2. When the laser is a glass tube, this pin will be connected with the laser
power PWM end and used to control the power of the laser.
4
WP1
The input port of water protector for the first laser power source. When
the water protector 1 is enabled, the mainboard will detect the input
port of water protector 1. If this port is of low level, it will be deemed
normal; if this port is of high level, the mainboard will forcibly close the
laser to suspend the work in progress and the system will warn. If the
water protector 1 is not enabled, the mainboard will not detect the input
port of water protector 1 and so the water protector 1 can be
unconnected.
Water protection input must be 24V logic level.
5
L-AN1
The analog signals for Laser Power. If Glass Tube is used, this pin is
recommended to control the power of the Laser.
Please correctly select the laser type in the factory parameters.
Prompt