Ruida Technology RDV6442G - User Parameters

RDV6442G Control System manual V1.3
SHENZHEN RUIDA TECHNOLOGY
45
If it is only provided with the single laser, it can show the one-path
parameter.
（3）Other manufacturer parameters
Machine configuration
 Machine Type: In most cases, the general engraving machine should be selected and
other types used for specific purposes.
 Transmission Mode: generally the
“
Belt Stepping Type
”
should be made choice of. The
control algorithm will be changed a little when other types are selected.
 Feeding Mode: it has single-way mode and two-way mode for option. If it is of
single-way feeding, it is unnecessary to check the coordinates. Feeding can be conducted in the
single-way mode; if it is of two-way feeding, the system will check the maximum and minimum
coordinates. The odd sequence means feeding should be done to one direction and the even
sequence means feeding done to the other direction. The initial direction for the first time can
be changed through setting the directional polarity or modifying the plus and minus values of
the feeding length.
 Power-Off-Restart Delay: it can be set to be 0~3000ms. After the power-off of the
electricity grid, the power supply of the system will not drop to 0 at once. There is a delay
during this time. The delay value set here should basically consistent with the actual off-delay
value. If the deviation of set value is larger, on the de-energizing for continuous engraving,
either the figure processed for the second time is not closed with that before the cutoff, or it is
coincided with that too much.
After the configuration parameters in the manufacturer parameters,
such as directional polarity, control mode, laser type and laser PWM
frequency, are modified, the system should be reset. Such a modification
can function upon the resetting of the system.
Enable parameters
 Door Opening Protection: If this item is enabled, then the door opening protection
must be connected to the controller, or, the machine will not run.
 Whether to enable the blower: If using wind out port to control the blower by the
graph layer parameter, this item must be enabled, or, the wind output is a signal for other
using.
9.2 User parameters
（
1
）
Cutting parameters(Only affect cutting arts)
 Idle Move Speed: this parameter decides the highest speed of all non-lighting lines for
the machine in the movement process.
 Idle Move Acceleration: it means the highest acceleration of all non-lighting lines. Idle
Prompt
Prompt