Ruida Technology RDV6442G - Speed Key

RDV6442G Control System manual V1.3
SHENZHEN RUIDA TECHNOLOGY
29
Figure 8.2-1
●Graph Display Area: To display the whole file’s track, and display the running track.
●
Running parameters: To display the running file
’
s file number, speed, max power etc.;
●Coordinate: To display the current coordinate of X,Y and Z axes
●Graph layer parameters: To display the layers’ information of the current file, such as max or min
power, speed etc.. When system is idle, dblclick the layer, then users can change the layer
’
s parameters
and the changing would be saved.
●Running Status: To display the current status of the machine, such as Idle, Run, Pause, Finish, etc.;
●
Running Progress Bar: To display the progress bar of the current running file;
●Working Number: To accumulate the work number of the current file.
●File Dimension: To display the dimension of the current file;
●
Net status: To display the connecting status of the Ethernet.
When work is Idle or finished, all keys can be pushed, users can select a file to run, set some
parameters, preview to a select file etc. But, when work is running or paused, some keys don’t respond
when they are pushed.
8.2.2 Speed key
Push the “Speed” key when the screen is on the main interface, it will show as below: