Ruida Technology RDV6442G - Z Move; U Move; Axis Reset

RDV6442G Control System manual V1.3
SHENZHEN RUIDA TECHNOLOGY
32
Figure 8.3-1
Push “Y+/-” keys to move the green block to the anticipant item, and then push the “Enter” key
to display the sub menu.
8.3.1 Z move
When the green block is on “Z Move” item, “X+/-” keys can be used to move the z axes.
8.3.2 U move
When the green block is on “U Move” item, “X+/-” keys can be used to move the u axes.
8.3.3 Axis reset+
When the green block is on this item, push the
“
Enter
”
key to show as below: