37
< Return to Table of Contents
Beep Codes
Confidential and Proprietary - Property of Techtronic Power Equipment - DO NOT COPY or DISCLOSE
EXAMPLE ERROR CODE: A0 0000000
BEEP # DESCRIPTION CHECK IF NOT SOLVED…
1
Angle Sensor not
at neutral
Wiring and connections; ensure
solid connection and no loose
wires
Replace Mixing Board
Replace both Drive Motor
Controllers
Replace iDRIVE
2 Over Current Return Joystick to neutral
Replace both Drive Motor
Controllers
3 Motor Stall Return Joystick to neutral
Turn mower off; push unit by
hand to see if easily pushed; if
not, check which side is harder
to push
Lift mower up to allow rear
wheels to spin freely; check
each wheel and replace Drive
Motor/Transmission Assembly
on binding side
4 Seat Switch open
Use hand to push down center
of seat and repeat
Check Seat Switch connection
and wiring
Disconnect Seat Switch and
short circuit the male terminal;
if resolved, replace Seat Switch
5 Under Voltage
Fuel gauge if battery was
charged above 5%; if not,
charge unit
7
Over
Temperature
Return Joystick to neutral Wait 30 minutes and repeat Replace Drive Motor Controllers
8 Hall Sensor fault Return Joystick to neutral
Check connectors; unplug and
plug in again
Replace Drive Motor/Gearbox
Assembly for affected side
10 Com Port Turn key off, then back on Replace Drive Motor Controllers
11 Com Port Turn key off, then back on Replace Drive Motor Controllers
13 Self Test
Check Charger connection;
unplug and plug in again; tug on
wires to see if loose
Turn mower off; push unit by
hand to see if easily pushed; if
not, replace Drive Motor
Controllers
17
Angle Sensor
failure
Return Joystick to neutral Check Angle Sensor connections Replace control lever assembly
19 AD Error Return Joystick to neutral Replace control lever assembly
20 CPU Error
Turn key off; return Joystick to
neutral; turn key on
Replace Drive Motor Controllers
To Next Page
Loading...
